Reset a Samsung galaxy young gt-s5360 using two different methods

I followed ODIN v3 instruction to flash new firmware on a Samsung sm-j110h but it doesn't open or even show charging?

After I'm done flashing firmware using ODIN, it shows PASS however after that the phone doesn't open anymore. I even tried charging it but nothing happens on the screen, it doesn't even show that the battery is charging. What can I do to solve this? My phone doesn't even show charging, I tried charging it for a while but nothing happened even a battery that shows charging doesn't show in my phone it's really dead.

VisiHow QnA. This section is not written yet. Want to join in? Click EDIT to write this answer.

Phone doesn't boot, even after ODIN flash?

Phone doesn't boot, even after ODIN flash...

If you have correctly followed all of the above instructions and had success on flashing your stock firmware to your phone via ODIN, but your phone is still stuck on boot, please perform a Hard Reset on your phone by following the steps above on how to Hard Reset your phone. Sometimes it still gets stuck on boot even after re-flashing your phone with its stock firmware. If after doing a Hard Reset and you are still stuck on boot, please flash your stock firmware again via ODIN and follow the instructions above carefully this time, you must have missed something when you re-flashed your phone using the instructions above.

This could be a battery issue. Attempt to find a friend with the same phone/battery. Put the known good battery in your phone and allow it to charge. If it boots up with the other battery then you know what to fix. If not, you may need to take it to a phone repair technician or send it off to one, it is most likely a hardware problem, not a software one.

Stuck on splash logo with no recovery, flashing does nothing?

Hi, man, I got a big problem; n7000 stuck on Samsung GT n7000 logo, won't get to Samsung blue circle logo, can't enter recovery, only download mode, flashed stock firmware with ODIN, still the same. Any ideas, what I can do more?

VisiHow QnA. This section is not written yet. Want to join in? Click EDIT to write this answer.

My sgy having boot loop what can I do if it is not staying in recovery or ODIN mode?

Please tell me.

To fix the boot loop problem on your phone, please do the following.

• Turn your phone off.

• Follow "Method 2: Hard reset" instructions in this wiki.

• If you are still stuck in boot loop after Hard Reset, please follow "What to do in case of a boot-loop" instructions in this wiki.

• If none of the above methods worked for you, your phone may require service.

During flash the device is continuously not in download mode?

During flash, the device is continuously, not in download mode. If it is not continuously in download mode how to flash it?

If the device is not taking the flash then you will need to find a way to get the device to stay in download mode. I will need to know your mobile device in order for me to give you better information on how to keep the device in download mode to accept your flash.

I tried to get into Recovery Mode by pressing Volume up, Home, and Power buttons but it won't boot into Recovery mode. Nothing is happening; the next screen is not coming?

This happens when you pressed and hold the Power button ahead Volume up and Home buttons. The trick in booting into Recovery mode is to press and hold the Home and Volume Up first then press and hold the Power button. This way, the phone will correctly recognize the set of command and boot into recovery. If the phone won't respond. Try to boot it up and see if the phone will attempt to start. If it won't then the battery could be drained. Charge your phone for about fifteen minutes before attempting to turn it on again.

See more questions like this: Phone says "Too many pattern attempts" on my Galaxy Y. How can I unlock it

How to fix boot loop/bricked in Galaxy Note II E250s?

A week ago my phone hangs up suddenly it shuts down. I rebooted many times but stayed at the Note2 logo. I entered custom recovery. I clicked fix context in TWRP hoping it would fix my problem. Unfortunately, it worsens it. phone got stuck up on logo after 5 sec. it shuts down.The worst thing is that I can't boot up my phone unless plugged in.I tried reflashing Stock Firmware via ODIN still boot loop then shuts down. I think my problem is more complicated than what is in the article. I have tried: Tried rooting it even I can't enter the phone.

tried flashing custom recovery via ODIN. I think it was caused by: Corrupted memory

messed up with fix context in TWRP

VisiHow QnA. This section is not written yet. Want to join in? Click EDIT to write this answer.

My mobile is not accepting any apps to download from Google play store and if I download any videos in my UC browser the downloaded item is not showing in downloads folder?

Please help me to get out of this problem because this is my first mobile I bought from my salary. I have tried: Nothing. I think it was caused by: I think the problem is in system cache

VisiHow QnA. This section is not written yet. Want to join in? Click EDIT to write this answer.

See more questions like this: Before anything else, I just want to ask does assisting me has a price?

In the step: "Hold and press the Volume up, Home, and Power buttons simultaneously for 10-15 seconds." Screenshot once holding the combinations?

In the step: "Hold and press the Volume up, Home, and Power buttons simultaneously for 10-15 seconds." Screenshot once holding the combinations

If you are using the combinations to be able to go to the boot menu option or recovery. The key combinations are;

• Volume +

• Menu button

• Power switch

But sometimes these key combinations may differ on each phone. I think this combination works well on Samsung Galaxy young s5360. But, you must first turn off your phone before doing the key combinations, cause it won't work if the phone is turned on.

My phone does not open its stuck on log on screen with FRP locked?

As I was using ODIN v3, it displayed PASS and then the phone (Samsung S7) powered on and was stuck on logo screen with FRP locked.. Please help

VisiHow QnA. This section is not written yet. Want to join in? Click EDIT to write this answer.

See more questions like this: My phone is on and off with a log on screen having FRP locked while using ODIN v3. What is the solution?

If you have problems with any of the steps in this article, please ask a question for more help, or post in the comments section below.

Comments