Edited by MENSAH MAXWELL, Eng, Maria
Questions and Answers
My Tecno M3 phone only vibrates after flashing?
When I used the SP flash tool to flash my Tecno M3, it is stuck at the logo and eventually went off. Please, any solution can be posted to me via my email. Thanks
You bricked your device. This is why it will not go past the bootup screen. You can try to hard reset the device but if it is bricked then this may not work still. Remove the battery and plug the phone into the wall charger. Leave it for at least 15 minutes and try again.
MY PHONE Tecno M3 HAS VIRAL BLOCKAGE?
THE SOFTWARE IS FAILING TO WORK
Hard reset your Tecno M3 if you suspect a virus. If you are unaware of how you got the virus then a hard reset will get rid of it hopefully with whatever mode it was sent to you in. You will want to put the phone into Recovery and first choose Wipe Cache Partition and then Wipe Dalvik Cache. Then hard reset the device. In the future, use a malware app to avoid further viruses.
My Tecno m3 phone goes off on it's own and when I want to power it on, it will power and then goes off. How do I rectify it?
My Tecno m3 phone goes off on it's own and when I want to power it on, it will power and then goes off. How do I rectify it?. I have tried: Nothing. I think it was caused by: I think the phone fall to the ground
You have a loose connection. Take the back off the phone and remove the battery. Firmly press two fingers all over the back of the phone. Then see if the phone works better. If not you will have to have it repaired or try to repair it yourself.
More questions and answers on this topic can be found here: How do I hard reset Tecno M3 Android
If you have problems with any of the steps in this article, please post in the comments section below.
Categories : General Android Mobiles & Tablets
Recent edits by: Eng, MENSAH MAXWELL