Loosen a tight lock nut on a faulty faucet
Edited by Maria
It can be a real pain getting your faucet fixed. It is a bigger pain even having it broken in the first place.
Even more infuriating is waiting for the repairman to fix the problem. The plumber who comes to fix your pipes is going to cost you something, that's a fact. The thing is that sometimes it's possible for you to fix your own faucet and not have to pay the piper so to speak. Here are a few tips on how to fix your own faucet -- DIY style!
- 1Inspect your Faucet.You have to make sure that your faucet will be able to withstand another troubleshooting. Too much rust, grime or mildew on the faucet can indicate that it is beyond help. To inspect it, try bending the metal pipe near the faucet, or scrape some rust off it so that you can see the condition of your faucet before you begin loosening anything.Advertisement
- 2Hammer or Unhinge Faucet.One of the most reliable ways of loosening a tight lock nut is by hammering it. This method can sometimes instantly loosen the lock and allow you to manually unscrew it. Otherwise you can use a wrench to loosen the lock, breaking off any rust that has accumulated therein. Be careful though, as both these methods can damage your faucet.Advertisement
- 4Soak the Nut in Water.If the nut you are loosening is covered with crumbly bits of rust or yellow streaks, which show corrosion, soak it in water and just scrub the corroded parts. You can also use soapy water for easier scrubbing. After this, dry the area and spray a lubricant, like Liquid Wrench, as close to the tight lock as possible and turn hard. For better results you can apply the oil and leave it on for 24 hours. This will give the oil more time to perform.Advertisement
When All Else Fails
If the nut resists all the above attempts, use a hacksaw or a reciprocating saw to cut it off. You can then proceed to have it repaired by a pipe man, or do it yourself. You will saves a lot of money if you can manage to do it on your own.
Tips Tricks & Warnings
- Always wear a protective suit when undertaking repair jobs.
- Work in a well ventilated and lighted area as to avoid accidents and hasten your work.
- Use the proper tool for the specific job you are trying to accomplish.
Questions and Answers
How to loosen a tight bolt on a spigot?
Do the following to loosen it up:
- tighten it- try to move it in any direction and use the correct sized tool for it
- tap it with a hammer with care
- apply some heat to it- because metal expands slightly when hot
- soak it with oils like WD-40 or liquid wrench to loosen it
If all else fails, cut it off.
- If you have problems with any of these steps, ask a question for more help, or post in the comments section below.
Categories : Home Repair